Rife Machine Premium Quality Replica
We make to order exact replicas of the original Rife Machine – Beam Ray device (MOPA). Rife machine replicas are produced strictly following the technical specification of the historical device made by Dr Royal Raymond Rife and his engineer Philip Hoyland. The resulting output is identical to the one produced by the original Rife Beam Ray machine.
Unlike most devices available on the market, our replica utilises a sidebanding method to generate a set of harmonics capable of reaching the targeted MOR (Mortal Oscillatory Rate) and its harmonic frequencies with minimal output signal filtering.
Historical Rife Beam Ray devices were designed with the technology and electronic components readily available in the 1930s and 1940s. It implies a higher cost of production and maintenance and less versatility for the user in a modern environment. We addressed those issues by improving and adding several things:
- The device doesn’t contain any internal modulation signal generator. Instead, an internal preamplifier of the modulating signal input is provided for using an external signal generator. That way, the user has a much broader choice of signal sources to use, ranging from a computer soundcard to advanced function generators. Effectively, any signal source capable of providing sinusoidal wave with at least 5V output and frequency range of up to 20 (30) kHz.
- The power supply of the thermionic valve triode heater is stabilised DC voltage source. It provides accurate electrical potential (voltage) even in events when the electrical potential of the electrical mains varies. That way, the longevity of the triode heating filament is preserved if unfavourable conditions occur.
- The anode power supply employs a soft start circuit to reduce stress on the thermionic valve triode and increase its longevity. The internal microcontroller controls the start/stop sequence to simplify the use of the device.
- The vacuum tube triode is actively air-cooled to reduce thermal stress during high power operation.
- Carrier wave frequency is adjustable, while historic devices had fixed carrier wave frequency. The fixed carrier frequency was used to hide the true MORs by providing users with the pre-set list of audio range frequencies necessary to produce LSB harmonics, one of which would be the exact MOR. For more versatility, the carrier wave frequency is adjustable, and it covers one of the historical ranges of 3.3 MHz. However, it also provides the possibility of setting the carrier wave frequency to some lower value, usually down to 2.6 MHz. That way, the user is provided with the option of targetting MORs (Mortal Oscillatory Rate) by using a lesser number of LSB (Low Side Band) harmonics, i.e. by using a smaller number of “steps”. It means that the harmonic at the targetted MOR shall contain more energy, which most likely translates to better efficacy of the device. The user can measure the exact carrier wave frequency with the external frequency meter, oscilloscope etc.
- The output power can be increased or decreased. It is done by removing the enclosure top lid and turning the shaft of the adjustment rheostat while observing the anode current value on a front panel instrument and grid leak current (any milliampere meter which can connect to the socket on the rear side).
- The plasma antenna we commonly use is the larger version of the Phanotron tube. It comes with a plexiglass holder with holes for mounting on some moveable stand. The polymer caps on the end of the tube make it easy to replace and provide a very high safety level from accidental touch.
- Warranty on all parts is 36 months except expendable parts, i.e. Phanotron tube – plasma antenna and thermionic valve triode.
May 2023 update: Please note there is a shortage of quality thermionic valve triodes on the market that we purchase as new old stock. Some poor-quality triodes are available, but we only choose premium-quality components for our replicas. Until adequate triodes become available again, we have suspended production.
